CAN-BUS resistor CBW1 with DIP-switch. Our newly developed CAN-BUS
resistor CBW1 fits most vehicles that have a CAN-BUS system. The CBW1
resistor provides a required electrical load for your vehicle, which, if
the dip switches are set correctly, will result in no flashing of the
accessory flashers in the cockpit. In addition, a reliability is given.
This means: If the accessory indicators fail due to an electronic fault,
an error message is immediately displayed in the cockpit. Up to 2
channels can be operated, such as turn signals at the rear left and turn
signals at the rear right. If 2 pairs of indicators need to be
changed,also 2 CBW1 needed to be used. Which requirements should be met
in order to use the CBW1 on the motorbike: Either: The motorbike was
originally produced with LED indicators. Or: The motorbike has a CAN-BUS
System If these requirements are not met, the CBW1 unit will not
function (!) The following resistance values can be set on the CBW1:
150 ohms 170 ohms 240 ohms 300 ohms 400 ohms 600 ohms 1200 ohms
Dimensions: Height = 11mm Width = 31mm (without straps) Width = 46mm
(with tabs) Length = 40mm Cable length = 200mm with pins Connections:
Yellow = input channel 1 (+) Orange = output channel 1 (+) Blue = input
channel 2 (+) Red = output channel 2 (+) Gray = input mass (-) Black =
output ground (-) Scope of delivery: 1 piece Hints: – Up to 2 channels
can be operated. – The connection is explained precisely in the mounting
instructions!
Note: We reserve the right not to publish offensive or inappropriate comments and criticisms on our website and we thank you for your attention. Your contribution will only be published anonymously.